| Quantity | 3+ units | 10+ units | 30+ units | 50+ units | More |
|---|---|---|---|---|---|
| Price /Unit | $8.15 | $7.99 | $7.74 | $7.40 | Contact US |
AXera PI Zero Module 5MP AI-ISP Camera Module Designed with SoC Chip AX620Q+SC450AI Image Sensor
$67.98
0.5-inch 1024X768 OLED Driver Board High Quality Circuit Board for V760A-5 Wearable Head Mounted Display
$40.24
1PCS SFP+ Dual Mode Optical Module Small Form-factor Pluggable Transceiver Support 10Gbps Transmission with LC Interface
$26.09
Arduino HMC5883L Digital Electronic Compass Sensor Navigation Module for DIY
Specification:
- Measurement Chip:HMC5883L
- Voltage: 3.3V
- Current: 20mA
- Accuracy: 1 degree
Features:
- 3-axis magnetoresistive sensor and ASIC are packaged in 3.0 × 3.0 × 0.9mm LCC surface assembly
- 12-bitADC and low interference AMR sensor that can achieve 5 gigahertz resolution ± 8 gauss magnetic field
- Built-in self-test function
- IC Digital Interface
- Leadless package structure
- Wide field range (+/- 8Oe)
- A corresponding software and algorithm support
- Maximum output frequency up to 160Hz
- HMC5883L electronic compass is a digital sensor which can be used to navigate the robot.
- Sensor module is connected via the serial port rx tx to the controller output digital 0-360.
- LED lights to indicate the direction of the corresponding angle between the sensor and the earth's magnetic field current.
Advantages:
- Make the compass precision up to 1 degrees to 2 degrees
- Suitable for battery powered
- With set / reset and bias drive for degaussing, self testing and offset compensation
- Suitable for consumer electronic devices in general two-wire serial data interface
- Can get compass course,hard, soft magnetic and automatic calibration Library
- Can be applied to personal navigation system and LBS
Package included:
- 1 x Module
