ARKBIRD A Flight Control System Autopilot Stabilizing + OSD RTH Flight & GPS AIO free soldering

ARKBIRD A Flight Control System Autopilot Stabilizing + OSD RTH Flight & GPS AIO free soldering

Kit included :
- Stablization System OSD R-T-H Return Flight Controller Board,
- GPS Module,
- Current sensor

Product Features
ARKBIRD Flight Stabilization System is a high-accuracy stabilizer designed for fixed-wing, which has

capability of auto-balancing to ease the manipulation while flying. 
1. Attitude sensor through barometer, reliable design; on-board voltage regulation chip, “ESC+ voltage regulation”dual voltage design.
2. Inertial measurement unit, suitable for any kinds of weather environment.
3. Applicable for small-space model, support delta-wing.
4. Easy to adjust, which saves much time for adjustment and applicable for most models. Intelligent PID controller.
5. One button auto-leveling, one button return-to-home, go home once radio turn off.
6. Return-to-home even the signal from GPS satellite is poor.
7. Gyro normal balance and 3D balance.
8. One button hover mode. 
9. Straight constant-height flight.
10. Switching to Return-to-Home Mode while flying over the rectangle area

Specifications:
- Size (w/o pin): 50 x 38 x 14mm
- Weight of Arkbird (w/o cable and cover): 26.8g
- Weight of Current sensor (w/o cable and cover): 12.6g

Notice and install tips:
As AIRBIRD has no reverse polarity protection, any incorrect wiring will damage the product, please pay attention while installation.
Please note that ARKBIRD shall be leveling during installation including pitch and roll. You may adjust through observation of OSD artificial horizon.
MUST keep the transmitter setting as default, especially end-point, travel range, and sub-trim. Any problem, please adjust the control link of plane.
Please be reminded that test without wind.