Crius All In One PRO Flight Controller V1.0 Support MegaPirateNG and MultiWii Bended Pin Version
  • Crius All In One PRO Flight Controller V1.0 Support MegaPirateNG and MultiWii Bended Pin Version
  • Crius All In One PRO Flight Controller V1.0 Support MegaPirateNG and MultiWii Bended Pin Version

  • SKU:16882
    (0 reviews)   Write a review(Get Thanksbuyer Points!)
  • Availability: In Stock     Reward Points: 7
  • Price:$68.38
  • Price in reward points: 684
  • Buy more, save more
  • Quantity 3+ units 10+ units 30+ units 50+ units More
    Price /Unit $67.01 $65.64 $63.59 $60.86 Contact US

Crius All In One PRO Flight Controller V1.0 Support MegaPirateNG and MultiWii (Bended Pin)
Features:
 - Supported MegaPirateNG and MultiWii firmware
 - Up to 8-axis motor output
 - 8 input channels for standard receiver
 - 4 serial ports for debug/Bluetooth Module/OSD/GPS/telemetry
 - 2 servos output for PITCH and ROLL gimbal system
- A servos output to trigger a camera button
 - 6 Analog output for extend device
 - A I2C port for extend sensor or device
 - Separate 3.3V and 5V LDO voltage regulator
 - ATMega 2560 Microcontroller
 - MPU6050 6 axis gyro/accel with Motion Processing Unit
 - HMC5883L 3-axis digital magnetometer
- MS5611-01BA01 highprecision altimeter
- FT232RQ USB-UART chip and Micro USB receptacle
- On board logic level converter
- Match the standard of RoHS

*Pls note the pins of this version are bended ,not straight pin

- Flight mode for Multiwii
 - One of the following basic mode
  - Acro
  - Level
  - Alt Hold
  - Head Lock
 - Optional mode
  - HeadFree (CareFree)
  - GPS Hold (Need GPS receiver or Extend Board)
  - GPS Back to home position (Need GPS receiver or Extend Board)

- Flight mode for MegaPirate
 - Acro
 - Alt Hold
 - Simple
 - Loiter (uses GPS)
 - Guided (uses GPS)
 - Position (uses GPS)
 - Circle (uses GPS)
 - RTL (uses GPS)
 - Auto(uses GPS)
 - Follow Me(uses GPS)

- Input power selection
- One of the following way
  - Connect 5V power cable from ESC or UBEC to the ESC/Servo port, the J1 jumper must be closed.
  - Connect 5V~12V power cable to the extend power port, the J1 jumper must be removed.
   When using Extend Board, AIO PRO must be powered from the extend power port.

General
- Dimension: 50mmX50mm
- Height: 11.6mm
- Weight: 14.2g
- Fixing hole spacing: 45mm
- Hole diameter: 3mm

Package content
- AIO PRO FC x 1
- 3Pin to 1Pinx3 cable 100mm x 3
- 3Pin to 3Pin cable 100mm x 1
- Molex 1.25mm 4Pin cable 100mm x1
- Molex 1.25mm 6Pin cable 100mm x2
- Molex 1.25mm 8Pin cable 100mm x1

Related Products
What other people are saying

Write a review

Your Name:
Your Review:
Note: HTML is not translated!
Rating:
Bad    
Enter the code in the box below:

Copyright © 2012-2015 ThanksBuyer.com . All rights reserved.