EBD-USB Load QC2.0 3.0 MTK-PE Trigger Voltage Current Monitor Capacity Tester Detector Micro Interface

EBD-USB Load QC2.0 3.0 MTK-PE Trigger Voltage Current Monitor Capacity Tester Detector Micro Interface

Description:
EBD-USB is a dedicated USB small load for testing the mobile power and charging head, support QC and MTK protocol for charging voltage trigger detection and USB charging voltage current measurement. (Using through EB software online).

Specification:  
- Power supply: on line power supply (5V)
- Voltage range: 0.05-13.50V
- Current range: 0.05-4.000A
- Test mode: constant current discharge, QC2.0/3.0 trigger, MTK-PE trigger, USB current voltage detection
- Maximum power: 25W
- Computer control software: support EB online software testing (computer control, drawing curves, calibration measurement benchmark, upgrading equipment firmware, power supply current testing, etc.)

Note: This is the Micro interface with built-in online On-line converter and suitable for common Mincro USB cable.

Brief Introduction of usage:
1. Download EB V1.8 Build 1018 software and PL2303 drive and install: Click here http://zke2006.blog.163.com/blog/static/199527095201111284512232/
2. EBD-USB MicroUSB data cable (or MiniUSB) connected with the computer
3. Find the corresponding port in the computer device manager (which can refer to the software instructions)
4. Open the EB software, select the corresponding port, connection equipment and testing

Package included:
- 1 x Tester