Optimized user interface When charging or discharging, B8 has an "AUTO" function that sets the feeding current automatically. Especially for Lithium batteries, it can prevent the over-charging that can lead to an explosion by user's fault. Every program in the unit is controlled with mutual links and communication for every possible error for maximum safety. These can be set at user's option. Special recharger plugs port for receiver, transmitter and igniter charger. And for frequently used charger port such as multi purpose crocodile pin etc. It provides most convenient balance charger port for Lithium batteries, with separated 2,3,4,5,6,7,8charge port, and external reverse connector.
High-Power and high-performance circuit B8 employs the circuit that has maximum output power of 150W. As a result it can charge or discharge up to 27cells of NiCd/NiMh and 8series of Lithium batteries with maximum current 7.0A. Furthermore the cooling system is so efficient that can hold such a power without any trouble of running the CPU or the operating program.
Individual voltage balance for Lithium batteries inside
B8 has an individual-cell-voltage balancer inside. This does not require any extra balancer when charging Lithium batteries (LiIo/LiPo/LiFe) for cell voltage balancing.
Balance individual cells on discharge B8 also can monitor and balance individual cells of the Lithium battery pack during the discharge process. If the voltage of any one cell varies abnormally, the process will be stopped with the error message. Suitable for various types of Lithium batteries B8 can accept three types of Lithium batteries-LiIo, LiPo and LiFe. They have different characteristics by their chemistry. You can select any one of them that you are going to process before the job.
Lithium battery "Fast" and "Storage" mode You can charge Lithium battery for special purposes. "Fast" charge reduces the charging time of Lithium battery and "Storage" mode controls the final voltage of the battery be suit for long time storage.
Maximum Safety Delta-Peak Sensitivity: The automatic charge termination program works on the principle of the Delta-peak voltage detection.
Auto-charge current limit: When charging NiCd or NiMh at "AUTO" current mode, you can set the upper limit o charge current to avoid from high current charging. This is very useful when charging the low impedance and small capacity NiMh battery in "AUTO" mode. Capacity Limit: The charging capacity always calculated by multiple of the charging current and time. If the charging capacity exceeds the limit the process will be terminated automatically when you set the maximum value. Temperature Limit: The temperature of the battery on charging will rise by its internal chemical reaction. If you set the limit of temperature the process will be expired forcibly when the limit has reached. Processing Time Limit: You can also restrain the maximum process time to prevent form any possible defect. Input Power Monitor: To protect the car battery using as input power from being damaged the voltage of it always monitored. If it drops below the lower limit the process will be ended automatically.
Data Store/Load For users convenience it can store maximum 10 data of different batteries. You can establish the data contains program setting of the battery to charge or discharge continually. These data can be called out at any time you need and the process can be executed without program setting.
Cyclic charging/discharging Perform 1to5 cycles of charge/discharge or discharge/charge continually for battery refreshing and balancing.
PC based analysis using USB communication For technical expert, B8 offers PC based program can analysis the characteristic of the battery by USB port. It shows a graph of voltage, current, capacity and temperature curves. It also shows the individual voltage of each cell in the Lithium battery pack. (*PC analysis software and USB Link wire are not included)
Multi-use wires You can charge and discharge your battery easily with these wires.