Industrial DKC-1A Stepper Motor Controller / Pulse Generator / Servo / Potentiometer Speed (D2B3)

Industrial DKC-1A Stepper Motor Controller / Pulse Generator / Servo / Potentiometer Speed (D2B3)

Description
    Wide voltage input,5-32DC;
    With a power anti-reverse protection , overvoltage protection, overcurrent protection, complete protection of the safety controller
    Signal input point for bottom -level input;
    OptimizedSType acceleration curve
    Maximum output frequency can be achieved20K
    All opto-isolated inputs and outputs
    Board planted potentiometer speed , external potentiometer speed automatic switching
    A variety of functions , set up a simple , functional and practical , volume 5 * 8.2CM

Function modes are:
1: Automatic shuttle mode
2 : Single Entry Mode
3 : Single-Shot mode
4 : Jog mode
:( Automatic control applications a round-trip mode )
1EquipmentAPointBRunning back and forth between points.
After the device is powered , external trigger startOperation, equipment operation toAPoint Forward LimitAfter running the automatic reversalBPointAfter reversing limit ,Forward run again toAPoint , so run back and forth . Until the trigger to stop the motor stops running.

Parameter settings:
1Set upSW1 = OFF,SW2 = OFF( Automatic shuttle mode )
2. Onboard governorOr external potentiometer,Adjust the appropriate speed.
:( Control application two single -shot mode )
1Equipment fromAPoint toBAfter stopping point . Again to stop the boot device from B to A points.
After the device is powered , external trigger startRuns from the device toAPointDeparture , when the device is running toBPoint Forward LimitAfter the device stops running , if you start again from point B to reach the trigger deviceAPoint , the device stops. Start upA-> B stop, start, B-> A stop motion process . If the trigger to stop the motor running in the device to stop running immediately .

Parameter settings:
1Set upSW1 = OFF,SW2 = ON( Single Shot mode )
2. Onboard governorOr external potentiometer,Adjust the appropriate speed.
:( Control applications three single round trip mode )
1Equipment fromAPoint toBA point after point to return to the stop .
After the device is powered , external trigger startRuns from the device toAPointDeparture , when the device is running toBPoint Forward LimitAfter the device is running a reverse rotation when it arrivesAPoint , the motor stops. Complete a
A-> B-> A motion process . If the trigger to stop the motor running in the device to stop running immediately .

Parameter settings:
1Set upSW1 = ON,SW2 = OFF( Single round-trip mode )
2. Onboard governorOr external potentiometer,Adjust the appropriate speed.
Control applications four :( jog mode )
1External switch controller starts again completely stopped, reversing.
After power on the device to start the input of the bottom level of the motor forward run ,
Bottom level undo , the motor stops .
To stop the input of the bottom level of the motor reverse run ,
Bottom level undo , the motor stops .

Parameter settings:
1Set upSW1 = ON, SW2 = ON( Jog mode )
2. Board governorOr external potentiometer,Adjust the appropriate speed.