| Quantity | 3+ units | 10+ units | 30+ units | 50+ units | More |
|---|---|---|---|---|---|
| Price /Unit | $6.65 | $6.52 | $6.31 | $6.04 | Contact US |
WIFI V2.0 Pixhawk 2.4.8 Flight Controller w/ I2C Expansion Board + PPM Encoder + RGB LED Indicator
$150.12
WIFI V3.0 Pixhawk 2.4.8 Flight Controller w/ I2C Expansion Board + PPM Encoder + RGB LED Indicator
$156.37
GEPRC GEP-F405-HD V2 Flight Controller Plug and Play STM32F405 Chip ICM42688-P Gyroscope for DJI Air Unit
$32.08
Matek WS2812B LED and 5V Active Buzzer Integrated Board for Naze32 Skyline32 Flight Control
Features:
- Can be used on Naze32, Skyline32 flight controller.
- Available states: Flight control lock/unlock, left/right aileron, brakes, accelerator, alarm etc.
Specifications:
- LED: RGB5050 High Brightness WS2812B LED Chips*6
- Voltage: 5V(4~7V)
- Dimensions: 50*10mm
- Weight: 3g
- Platform: Arduino, Naze32, Skyline32, SPRacingF3 flight control(need to updated CleanFlight)
Note:
If it is used for Naze32 or CC3D flight control,it need to brushed CleanFlight, and using PPM receivers.
Used for CC3D flight controller,you should pay attention to the following points:
-CC3D need to brushed CleanFlight firmware.
-Using PPM / SBUS receiver, you don’t use PWM receiver.
-GND 5V DIN behind the lights should connected to CC3D fifth row - + S of the motor output side.
-Choosing PPM receiver in the CF's assistant software configuration,then choose LED_STRIP options.
-Finally into the CF assistant software LED Strip Page to setup various states.
Package Included:
- 1x Integrated Board
