• New Mini APM PRO Flight Control with Ublox Neo-6M GPS & V2 915Mhz Telemetry & Mini OSD for FPV Multicopter Aircraft
  • New Mini APM PRO Flight Control with Ublox Neo-6M GPS & V2 915Mhz Telemetry & Mini OSD for FPV Multicopter Aircraft
  • New Mini APM PRO Flight Control with Ublox Neo-6M GPS & V2 915Mhz Telemetry & Mini OSD for FPV Multicopter Aircraft
  • New Mini APM PRO Flight Control with Ublox Neo-6M GPS & V2 915Mhz Telemetry & Mini OSD for FPV Multicopter Aircraft
  • New Mini APM PRO Flight Control with Ublox Neo-6M GPS & V2 915Mhz Telemetry & Mini OSD for FPV Multicopter Aircraft
  • New Mini APM PRO Flight Control with Ublox Neo-6M GPS & V2 915Mhz Telemetry & Mini OSD for FPV Multicopter Aircraft
  • New Mini APM PRO Flight Control with Ublox Neo-6M GPS & V2 915Mhz Telemetry & Mini OSD for FPV Multicopter Aircraft
  • New Mini APM PRO Flight Control with Ublox Neo-6M GPS & V2 915Mhz Telemetry & Mini OSD for FPV Multicopter Aircraft

New Mini APM PRO Flight Control with Ublox Neo-6M GPS & V2 915Mhz Telemetry & Mini OSD for FPV Multicopter Aircraft

Availability: In stock, usually dispatched in 1 business day

  • Price:$91.80
  • Price in reward points: 918 Reward Points: 9
  • Quantity 3+ units 10+ units 30+ units 50+ units More
    Price /Unit $89.96 $88.13 $85.37 $81.70 Contact US
Quantity:

New Mini APM PRO Flight Control with Ublox Neo-6M GPS & V2 915Mhz Telemetry & Mini OSD for FPV Multicopter Aircraft

Mini APM Pro Description:
- APM PRO, the new generation of APM
- Size: 60*38*14mm
- All interfaces are moved to the two sides, the middle part is no longer used for wiring
- Standard 2.54 dupont plug

Improvements made on the basis of original 2.6
- 3.3V LDO is easy to be burnt down, so it is changed to the imported large current LDO, support continously output 500MA high performance power supply
- Two diodes are changed to Pixhawk Pix PMEG2005 super low differential voltage dynatron
- 22UF/16V capacity was added into 5V module to ensure stable power of main controller (2560 part).
- All interfaces are designed at the two sides
- Two individual RGB colorful light
- Compression version PWM input, it only needs 4 servo cables to realilze 8 channels PWM

915Mhz Radio Telemetry Features:
- Very small size
- Light weight (under 4 grams without antenna)
- Available in 915Mhz
- Receiver sensitivity to -121 dBm
- Transmit power up to 20dBm (100mW)
- Transparent serial link
- Air data rates up to 250kbps
- Range of approx 1 mile
- MAVLink protocol framing and status reporting
- Frequency hopping spread spectrum (FHSS)
- Adaptive time division multiplexing (TDM)
- Support for LBT and AFA
- Configurable duty cycle
- Built in error correcting code (can correct up to 25% data bit errors)
- Demonstrated range of several kilometers with a small omni antenna
- Can be used with a bi-directional amplifier for even more range
- Open source firmware
- AT commands for radio configuration
- RT commands for remote radio configuration
- Adaptive flow control when used with APM
- Based on the HopeRF HM-TRP radio module, featuring an SiLabs Si1000 RF microcontroller.

Mini OSD Rev. 1.1 OSD Features:
- APM has an companion OSD board called Mini OSD. It reads all the MAVLink data in the APM telemetry stream and overlays it on the video stream if you're using an on-board camera and wireless video transmitter. This is useful if you're flying in First Person View (FPV) mode or don't want to use a laptop at the field to see your telemetry data in the Mission Planner.
Instructions on connecting and using the Mini OSD board via the APM telemetry port are here. Connection photos with APM 2 and APM 2.6 are below.

Power Supply Module Description:
- PM function: used for detecting battery voltage and current, flight control board receives these two signals, calculating battery remaining power, and remaining flying time
- This module has BEC function, can output 5.3V DC, max 3A continuous current, supply stable power for flight control board
- The signal cable connector adopts Japan original connector, making the connection reliable
- The Mini APM Pro Power Module is a simple way of providing your Mini APM Pro with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through a 6-pos cable. The on-board switching regulator outputs 5.3V and a maximum of 2.25A from up to a 4S LiPo battery. The Power Module comes completely assembled with Deans connectors, and wrapped in shrink tubing for protection.

Ublox NEO-6M GPS Description:
- Newest Version Ublox NEO-6M GPS Module for Flight Control Model Aircraft GPS Module
- U-BLOX Ublox NEO-6M latest version of the GPS module serial output
- Ultra-small integrated integrated antenna is compatible with a variety of flight control
- GPS module to the host computer software
- for Mini APM Pro

Package Include:
- Mini APM PRO flight control x 1 (including shell)
- PWM dupont cable x 4
- 3M adhesive paste x 1
- Ublox Neo-6M GPS for APM Pro  x 1
- Power Supply Module for Mini APM Pro  x 1
- On-Screen Ardupilot Mega Mini OSD x 1
- V2 Dual TTL 3DRobotics 915Mhz 3DR Radio Telemetry  x 1
- Shock Absorber x 1
- Micro USB Data Cable x 1
- GPS Holder x 1

Write a review

Note: We will keep it confidential.
Note: HTML is not translated!
 
Captcha