4WD 60mm Mecanum Wheel Robot Car Chassis Kit w/ MG513 Encoder Motor for Arduino Raspberry Pi DIY Project STEM Toy

4WD 60mm Mecanum Wheel Robot Car Chassis Kit for Arduino Raspberry Pi DIY Project STEM Toy

Specification:

- Load capacity: 6kg

- Speed: 1.2m/s (M / s)

- Turning radius: 0m

- Wheel material: Aluminum Alloy 

- Base plate material: 4.5mm acrylic

- Motor power: 7W

- Rated voltage of motor: 12V

- Deceleration ratio 1:30

- Encoder: turn the wheel once, output 390 pulses (the tire can distinguish 0.23 ° rotation)

Note:(the car without suspension uses acrylic base plate, which can make the wheels slightly adaptive if it is a little soft. The car without suspension can't use aluminum alloy because if aluminum alloy is used as a rigid plate, there will be a wheel hanging in the air at 3 point direction , and the running effect of the car is very bad.)

We have the same design Aluminum alloy car chassis that with Suspension function, please consult us if you want to buy

Mecanum Wheel Moving Direction:

​What’s in the Box:

• 1x Acyclic Frame
• 4 x 60mm Mecanum wheels 
• 4 x 12V DC motors with MG513 encoder
• 1 set screws

Note:

• Not included any controller and battery.
• ​Unassembled kit, please leave your mailbox to get the installation manual.