AN-103 LoRaWAN Temperature and Humidity Sensors with Internal Antenna

AN-103 LoRaWAN Temperature and Humidity Sensors with Internal Antenna

Specification:
1.Master Parameter
- CPU: ARM-Cotex M3 kernel;Basic Frequency-32MHz;32bit
- Memory: 128KB, Flash/16KB, RAM/4KB, EEPRO
2.Hardware Parameter
- Sensor: Built-in Temperature and Humidity Sensors
- Built-in LoRa Antenna
3.Radio Performance Parameters
- Data Transmission Rate: 300bps~5.4bps
- Operating Frequency: CN470MHz~510MHz/EU863MHz~870MHz/US902MHz~928MHz
- Support LORAWAN & P2P
- Maximum Power: 17dBm
- Sensitivity: -140dBm
4.Electrical Properties
- Power Consumption: 36mW
- Battery Capacity: 3.6V/4000mAh
5.Working Condition:
- Temperature: -30℃~+80℃
- Humidity: 10%~90%
6.Characteristics of DC
- Built-in rechargeable lithium battery
- Supply Voltage: DC3.6V
- Sleep Current: 15uA
- Operating Current: 110mA
7.Ingress Protection: 67
8.Dimension: 168 x 81 x 36mm

Installation:
(1) Power on/off
- Power on: Moving magnet toward LoRa terminal center position sensor until hear the beep,
and the beep sound will automatically stop after 2 seconds that means power on, then you should remove the magnet.
- Power off: Moving magnet toward LoRa terminal center position sensor until hear the beep,
(2) Warning Beep
keep the magnet stay in the position, and the beep sound will automatically stop after 6 seconds that means power off, then you should remove the magnet.
- The beep ringing last about 2 seconds then stop, that means Power On
- The beep ringing for 3 times, that means Network Access
- The beep ringing last about 6 seconds then stop, that means Power Off
Note: When installing this equipment, please keep the transducer connector downward.