CR-C Multi Function Diesel Common Rail Injector Tester Tool Bosch Delphi Denso

CR-C Multi Function Diesel Common Rail Injector Tester Tool Bosch Delphi Denso


Production Introduction:
- CR-C multi function common rail injector tester  adopts Germany Imported PWM control chip that can accurately and effectively to imitate ECU drive signal for each work condition of injector. such as pre injection, emission point, full load point conditions. can drive kinds of brands .
- CR-C common rail injector tester is a easy operated tool, could do the test with the injector hand pumps. It’s small size and light weight, could meet the requires from repairman on the simple device of testing.

Technical Parameters:
- Produce Model:CR-C Common Rail Injector Tester
- Testing Range:atomization, pilot, emission and full load condition.
- Test Injectors:for bosch, for Denso, and for Delphi common rail injectors.
- Power Supply:AC 110/220V
- Working Temperature:-30C°-70C°
- Adjustable Width:  10 MS
- Size:110*250*190mm
- Outer Package Dimension:30*25*20cm

How to use of CR-C machine:
1.Put common rail injector directly or into the holder to be connected to the high-pressure oil pipe.
2.According to the injector brand to select consistent plug,connect all harness and injector rightly.
3.According to the injector brand to select consistent drive mode,same time can hear the injector solenoid value suction armature "Pa,Pa"voice.
4.Press the pressure calibrator constantly to provide appropriate injection pressure,normally the pressure value take 30~40MPA as best,and at this time can check the fuel injector atomization performance.
5.Throught external graduated cylinder,can test injector fuel quality and hydraulic oil withdrawer.

Kindly Note:CR-C common rail injector tester is only for electromagnetic injector, it is not with piezo function.

Package List:
- 1 x CR-C Common Rail Injector Tester