{"product_id":"for-tinysa-handheld-rf-spectrum-analyzer-2-8-quot-touch-screen-display-with-built-in-battery-four-modes","title":"For TinySA Handheld RF Spectrum Analyzer 2.8\" Touch Screen Display With Built-in Battery Four Modes","description":"\u003cp\u003e\u003cb\u003eBasic Specifications:\u003c\/b\u003e\u003cbr\u003e● ABS shell: 58.7mm x 91.3mm x 17.1mm (excluding the sizes of protrusions)\u003cbr\u003e● Frequency accuracy: \u0026lt;2ppm\u003cbr\u003e● Frequency stability: \u0026lt;1ppm\u003cbr\u003e● Display: 2.8 inch TFT (320 x 240) resistive touch screen\u003cbr\u003e● USB interface: USB type-C communication mode: CDC (serial)\u003cbr\u003e● Power supply: USB 5V 150mA, built-in 650mAh battery, maximum charging current 300mA, charging time 1 hour 2 hours\u003cbr\u003e\u003cb\u003e\u003cbr\u003eUser Interfaces:\u003c\/b\u003e\u003cbr\u003e* Display resolution 320*240 pixels\u003cbr\u003e* Screen diagonal 2.8\"\u003cbr\u003e* 16 bits per RGB pixels\u003cbr\u003e* Resistive touch control\u003cbr\u003e* Jog switch control\u003cbr\u003e* USB serial port control\u003cbr\u003e* Optional TTL USART port (SW not yet implemented) on the internal PCB\u003cbr\u003e* Linear power supply to avoid switching noise.\u003cbr\u003e* The input\/output specification of the tinySA is split over the 4 modes\u003cbr\u003e\u003cbr\u003e\u003cb\u003eLow Input Mode Specifications:\u003c\/b\u003e\u003cbr\u003e* Input frequency range from 100kHz to 350MHz\u003cbr\u003e* Input impedance 50 ohm when input attenuation set to 10dB or more.\u003cbr\u003e* Selectable manual and automatic input attenuation between 0dB and 31dB in 1 dB steps\u003cbr\u003e* Absolute maximum input level without attenuation of +10dBm\u003cbr\u003e* Absolute maximum input power with 30dB attenuation of +20dBm for short period\u003cbr\u003e* Input Intercept Point of third order modulation products (IIP3) with 0dB attenuation of +15dBm\u003cbr\u003e* 1dB compression point at +2dBm with 0dB attenuation\u003cbr\u003e* Power detector resolution of 0.5dB and linearity versus frequency of +\/-1dB\u003cbr\u003e* Absolute power level accuracy after power level calibration of +\/- 1dB\u003cbr\u003e* Lowest discernible signal using a resolution bandwidth of 30kHz of -102dBm\u003cbr\u003e* Frequency accuracy equal to the selected resolution bandwidth\u003cbr\u003e* Phase noise of -90dB\/Hz at 100kHz offset and -115dB\/Hz at 1MHz offset\u003cbr\u003e* Spur free dynamic range when using a 30kHz resolution bandwidth of 70dB\u003cbr\u003e* Manually selectable resolution filters of 3, 10, 30, 100, 300, 600kHz. Automatic selection of one of the 57 resolution filters.\u003cbr\u003e* On screen resolution of 145 or 290 measurement points.\u003cbr\u003e* Scanning speed of over 1000 points\/second using largest resolution filters.\u003cbr\u003e* Automatic optimization of actual scanning points to ensure coverage of the whole scan range regardless of the chosen resolution bandwidth\u003cbr\u003e* Spur suppression option for assessing if certain signals are internally generated or actually present in the input signal\u003cbr\u003e\u003cbr\u003e\u003cb\u003eHigh Input Mode Specifications:\u003c\/b\u003e\u003cbr\u003e* Input frequency range from 240MHz to 960MHz\u003cbr\u003e* As there is no input band filter strong signals outside the 240MHz to 960MHz range can cause distortion of the in-band signals\u003cbr\u003e* Absolute maximum input level without attenuation of +10dBm\u003cbr\u003e* Input Intercept Point of third order modulation products (IIP3) of -5dBm\u003cbr\u003e* 1dB compression point at -6dBm with 0dB attenuation\u003cbr\u003e* Power detector resolution of 0.5dB and linearity versus frequency of +\/-1dB\u003cbr\u003e* Absolute power level accuracy after power level calibration of +\/- 1dB\u003cbr\u003e* Lowest discernible signal using a resolution bandwidth of 30kHz of -115dBm\u003cbr\u003e* Frequency accuracy equal to the selected resolution bandwidth\u003cbr\u003e* Spur free dynamic range when using a 30kHz resolution bandwidth of 50dB\u003cbr\u003e* Selectable (automatic and manual) resolution filters of 3, 10, 30, 100, 300 and 600kHz\u003cbr\u003e* Optional 25dB to 40dB frequency dependent input attenuator. The power level error with this attenuator activated increases to +\/- 15dB\u003cbr\u003e* On screen resolution of 145 or 290 measurement points.\u003cbr\u003e* Scanning speed of over 1000 points\/second using largest resolution filters.\u003cbr\u003e* Automatic optimization of actual scanning points to ensure coverage of the whole scan range regardless of the chosen resolution bandwidth\u003cbr\u003e\u003cb\u003e\u003cbr\u003eLow Output Mode Specifications:\u003c\/b\u003e\u003cbr\u003e* Sinus output with harmonics below -40dB of fundamental\u003cbr\u003e* Output frequency range from 100kHz to 350MHz\u003cbr\u003e* Output level selectable in 1dB steps between -76dBm and -6dBm\u003cbr\u003e* Optional AM, narrow FM and wide FM modulation or slow sweep over selectable frequency span\u003cbr\u003e\u003cbr\u003e\u003cb\u003eHigh Output Mode Specifications:\u003c\/b\u003e\u003cbr\u003e* Square wave output\u003cbr\u003e* Output frequency range from 240MHz to 960MHz\u003cbr\u003e* Output level selectable in variable increments between -38dBm and +13dBm\u003cbr\u003e* Optional narrow FM and wide FM modulation or slow sweep over selectable frequency span\u003cbr\u003e\u003cbr\u003e\u003cb\u003eReference Generator Specifications:\u003c\/b\u003e\u003cbr\u003e* Optional square wave output with fundamental at -25dBm connected to high input\/output\u003cbr\u003e* Frequency can be set to 1MHz, 2MHz, 4MHz, 10MHz, 15MHz or 30MHz.\u003cbr\u003e\u003cbr\u003e\u003cb\u003ePackage Included:\u003c\/b\u003e\u003cbr\u003e- 1 x Set of Spectrum Analyzer\u003cbr\u003e\u003cb\u003e\u003cbr\u003eAttention:\u003cbr\u003e\u003c\/b\u003e- It is not an SDR receiver and does not provide any demodulation function!\u003cbr\u003e- It is not a frequency sweeper, and does not provide tracking source output. If you need a frequency sweep function, please use NanoVNA!\u003cbr\u003e\u003c\/p\u003e","brand":"TinySA","offers":[{"title":"Default Title","offer_id":40826351255601,"sku":"69185","price":56.33,"currency_code":"USD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0578\/4790\/6353\/files\/7077424529457_watermarked_0.jpg_0.png?v=1767897697","url":"https:\/\/www.thanksbuyer.com\/fr\/products\/for-tinysa-handheld-rf-spectrum-analyzer-2-8-quot-touch-screen-display-with-built-in-battery-four-modes","provider":"Thanksbuyer Online,SDR Radio, Testers and Measurement devices, Astronomy products,  Audio Amplifer and Decoders","version":"1.0","type":"link"}