{"product_id":"rf49dr-ultra-10m-6ghz-16r-16t-rf-direct-acquisition-development-board-ultrascale-rfsoc-14bit-7gsps-dac-14bit-2-5gsps-adc","title":"RF49DR-Ultra 10M-6GHz 16R 16T RF Direct Acquisition Development Board UltraScale+ RFSoC 14Bit 7GSPS DAC +14Bit 2.5GSPS ADC","description":"\u003cp\u003e\u003cb\u003eMain Chip Parameters:\u003c\/b\u003e\u003cbr\u003e- Master chip model: XCZU49DR-FFVF1760-2-I\u003cbr\u003e- Clock recommended maximum speed: PLL\/MMCM recommended maximum 775M\u003cbr\u003e- PS application processor model: four core Cortex-A53, main frequency of 1333M\u003cbr\u003e- PS real time processor model: dual core Cortex-R5, main frequency of 533MHz\u003cbr\u003e- DDR specification model: DDR4, model of MT40A512M16LY-075:E; PS side, 4GB capacity, 64 bit-width, 2400M; PL side, 4GB capacity, 64 bit-width, 2666M\u003cbr\u003e- Logic unit: 930300\u003cbr\u003e- Lookup table: 425280\u003cbr\u003e- DSP unit multiplier: 4272\u003cbr\u003e- FlipFlops: 850560\u003cbr\u003e- Block Ram: 38M Byte\u003cbr\u003e- Ultra Ram: 22.5M Byte\u003cbr\u003e- GTY (32.5G): 16\u003cbr\u003e- Component temperature range: -40 to 85℃\u003cbr\u003e- Speed level: -2\u003cbr\u003e- Chip level: industrial\u003cbr\u003e\u003cbr\u003e\u003cb\u003eRF-49DR-Ultra Functional Interface Description:\u003c\/b\u003e\u003cbr\u003e- Development board power supply: power supply through dedicated DC-5.5 interface, 9-12V DC-IN interface\u003cbr\u003e- Development board clock: 33.33M (PS), 100M (PL), 26M (PS GTR)\/156.25M (GTY)\u003cbr\u003e- Ethernet: gigabit RTL8211E, PS GEM3\u003cbr\u003e- USB interface: USB3.0 SLAVE, also support USB3.0 HOST\u003cbr\u003e- DEBUG: onboard UART+JTAG (FTDI solution) support ARM and FPGA development\u003cbr\u003e- Optical port: one QSFP28 100GE optic port, maximum speed rate of 28Gbps\u003cbr\u003e- EEPROM: one FM24C02 EEPROM, connect to PS\u003cbr\u003e- SD card slot: SD1 of PS, 2.0 interface, can be started (SD support up to 32G)\u003cbr\u003e- EMMC: SDO of PS, capacity of 32GByte\u003cbr\u003e- LED and button: power on or off\/reset, PS\/PL button\/PL LED, power status indicator\/DONE indicator, USB indicator, etc.\u003cbr\u003e- Boot setting switch: one BOOT toggle switch for boot setting\u003cbr\u003e- Power-on\/JTAG mode switch: one, used for setting automatic power-on\/whether JTAG support external switch\u003cbr\u003e- Onboard FLASH: 128M Bytes, two magnesium light particles\u003cbr\u003e- Heat dissipation interface: two 12V heat dissipation interface, GH1.25-3P terminal\u003cbr\u003e- Screen: onboard a 0.49-inch 64x32 OLED screen\u003cbr\u003e- Synchronization and GPS: onboard MMCX leads out 5 IOs that can be used for synchronization\/triggering, etc; Onboard a MAX-M10S GPS module for UBLOX\u003cbr\u003e- Power supply monitoring: the development board has the function of monitoring power supply voltage and current\u003cbr\u003e- Expansion IO port: lead out 16 x 3.3V single-ended TTL; 2lane PS GTR, 4lane GTY, the connector uses 60P BTB connector X0802WVS-60AS-LPV01\u003cbr\u003e- FMC interface: one FMC HPC interface, including LA+GT part, without HA HB; GT part led out two Quad (8tx + 8rx)\u003cbr\u003e\u003cbr\u003e\u003cb\u003eRF Functional Interfaces Parameters:\u003c\/b\u003e\u003cbr\u003e- ADC number: 16-channel ADC, 14Bit, maximum sampling rate of 2.5Gbps\u003cbr\u003e- DAC number: 16-channel DAC, 14Bit, maximum sampling rate of 7Gbps\u003cbr\u003e- RF range: 10M to 6GHz\u003cbr\u003e- SNR: \u0026gt;56dB at 1GHz (average battery than 57dB)\u003cbr\u003e- Isolation degree: better than -70dB\u003cbr\u003e- Channel consistency: the measured average error at 1G frequency is within the range of 0.25dbm, which is lower than 0.3dbm\u003cbr\u003e- RF connector: MMCX female socket, requires MMCX male connector, other interfaces require adapter cables\u003cbr\u003e- RF coupling mode: AC coupling mode, reserved ADC VCOM output\u003cbr\u003e- Impedance control: RFSOC to Balun differential 100 ohms, Balun to MMCX single ended 50 ohms\u003cbr\u003e- Note: The sampling rate of ADC and DAC is based on the actual device. ADC has a sampling rate of 2.5GSPS for 49DR 16-channel devices, and the sampling rate does not represent the RF frequency.\u003cbr\u003e\u003cbr\u003e\u003cb\u003ePackage Included:\u003c\/b\u003e\u003cbr\u003e- 1 x Development Board\u003cbr\u003e- 2 x Type-C Data Cable\u003cbr\u003e- 1 x 12V\/5A Power Adapter\u003cbr\u003e- 6 x MMCX RF Cable\u003c\/p\u003e\u003cp\u003e\u003cimg style=\"width: 1000px;\" src=\"https:\/\/www.comseek.com\/image\/catalog\/102474\/102474-01.jpg\"\u003e\u003c\/p\u003e\u003cp\u003e\u003cimg style=\"width: 1000px;\" src=\"https:\/\/www.comseek.com\/image\/catalog\/102474\/102474-02.jpg\"\u003e\u003cbr\u003e\u003c\/p\u003e","brand":"Thanksbuyer Online,SDR Radio, Testers and Measurement devices, Astronomy products, Audio Amplifer and Decoders","offers":[{"title":"Default Title","offer_id":41029173968945,"sku":"102474","price":13659.27,"currency_code":"USD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0578\/4790\/6353\/files\/1780041106-1.jpg?v=1780396675","url":"https:\/\/www.thanksbuyer.com\/fr\/products\/rf49dr-ultra-10m-6ghz-16r-16t-rf-direct-acquisition-development-board-ultrascale-rfsoc-14bit-7gsps-dac-14bit-2-5gsps-adc","provider":"Thanksbuyer Online,SDR Radio, Testers and Measurement devices, Astronomy products,  Audio Amplifer and Decoders","version":"1.0","type":"link"}