{"product_id":"edup-ep-ab009-20w-high-power-signal-amplifier-high-performance-wifi-amplifier-39dbm-wireless-signal-booster","title":"EDUP EP-AB009 20W High Power Signal Amplifier High Performance WiFi Amplifier 39dBm Wireless Signal Booster","description":"\u003cp\u003e\u003cb\u003eEDUP EP-AB009 20W High Power Signal Amplifier High Performance WiFi Amplifier 39dBm Wireless Signal Booster\u003cbr\u003e\u003cbr\u003eSelling Points:\u003c\/b\u003e\u003cbr\u003e- High power amplifier: Enhance your WIFI signal with a 20W amplifier, ensuring strong connectivity even in remote areas.\u003cbr\u003e- Long distance capability: Use this long-distance repeater to expand your WIFI range, suitable for drones and other devices.\u003cbr\u003e- 2.4GHZ WIFI signal enhancer: Use this 2.4GHZ WIFI signal enhancer to enhance your WIFI signal and ensure connection stability.\u003cbr\u003e- 20W wireless network extender: By using a 20W wireless network extender, maximize your network efficiency and provide reliable coverage.\u003cbr\u003e- Plug and play installation: With plug and play installation, it is easy to set up and use immediately without the need for drivers.\u003cbr\u003e\u003cbr\u003e\u003cb\u003eFeatures:\u003c\/b\u003e\u003cbr\u003e- Brand new and high quality. \u003cbr\u003e- Low-noise receive gain 2.5dB . \u003cbr\u003e- Led status: Green (transmit) \/ Red(receive) \/ Change TX with RX (mix red with green)\u003cbr\u003e- High gain, high value, high performance. \u003cbr\u003e- Wide working voltage 30 - 54V.\u003cbr\u003e- Plug-and-play, easy installation, no driver needed. \u003cbr\u003e- Ideal for increase the 2400-2500MHz frequency devices. Adopt time division duplex (TDD)\u003cbr\u003e- Increase the effective range and coverage area of your WiFi network. \u003cbr\u003e- Maximum output power of 20000mW by the booster.\u003cbr\u003e- The amplified wireless signal may even penetrate complex environments with many walls and obstacles. \u003cbr\u003e- Ideal for use with 2.4GHz wireless LANs, support 802.11b, 802.11g, 802.11n (2.4Ghz mode only).\u003cbr\u003e\u003cbr\u003e\u003cb\u003eSpecification:\u003c\/b\u003e\u003cbr\u003e- Frequency: 2400-2500MHz. \u003cbr\u003e- Operation mode: Bi-directional, half-duplex, auto-switching via carrier sensing. \u003cbr\u003e- Ultra low power consumption: 620mA at Pout 36dBm 48V\u003cbr\u003e- Input power: 8dBm (min.); -26dBm (max.)\u003cbr\u003e- Output power: 9 ~ 43dBm\u003cbr\u003e- EVM: 4% at 36dBm 802.11g 54Mbps OFDM 64QAM BW 20MHz\u003cbr\u003e- Output power: 20000mW\/43dBm nominal for 802.11b\/11Mbps\u003cbr\u003e- Connector: SMA, 50ohm\u003cbr\u003e- Transmit gain: 17dB±1 nominal\u003cbr\u003e- Receiver gain: 20dB±1\u003cbr\u003e- Receive noise figure: 2.5dBm nominal\u003cbr\u003e- Operating temperature: -40 to 70℃\u003cbr\u003e- Operating humidity: up to 95% relative humidity\u003cbr\u003e- Material: cast aluminum\u003cbr\u003e- Size: 225mm x 12mm x 24mm\u003cbr\u003e- Product weight: 190g\u003cbr\u003e\u003cbr\u003e\u003cb\u003ePrecaution:\u003c\/b\u003e\u003cbr\u003e- Make sure all power supply to the booster and the AP\/Router unit be disconnected before removing or changing antenna.\u003cbr\u003e- When finishing connecting the booster and the AP\/Router, restore power supply first to the booster and then to AP\/Router subsequently.\u003cbr\u003e- Waterproof, lightning protection equipment should be attached to outdoor antenna.\u003cbr\u003e- Keep away from heat and keep ventilated.\u003cbr\u003e- Please comply with local regulations of electromagnetic radiation.\u003cbr\u003e\u003cbr\u003e\u003cb\u003e\u003cfont color=\"#ff0000\"\u003eNote:\u003cbr\u003e- Power supply (not included) requires 12V\/5A.\u003cbr\u003e- If the output power is greater than 5W or above, it is recommended to enhance heat dissipation, such as increasing heat sinks or adding fans.\u003cbr\u003e- When connecting, you must screw the antenna first, then connect the upper and front -end faithful equipment, and finally supply power.\u003c\/font\u003e\u003c\/b\u003e\u003cbr\u003e\u003cbr\u003e\u003cb\u003ePackage Included:\u003c\/b\u003e\u003cbr\u003e- 1 x WiFi Amplifier\u003cbr\u003e- 1 x Antenna\u003cbr\u003e- 1 x Connection Cable\u003c\/p\u003e","brand":"Thanksbuyer Online,SDR Radio, Testers and Measurement devices, Astronomy products, Audio Amplifer and Decoders","offers":[{"title":"Default Title","offer_id":41028541153329,"sku":"98592","price":303.97,"currency_code":"USD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0578\/4790\/6353\/files\/1757985458-1.jpg?v=1780314345","url":"https:\/\/www.thanksbuyer.com\/ja\/products\/edup-ep-ab009-20w-high-power-signal-amplifier-high-performance-wifi-amplifier-39dbm-wireless-signal-booster","provider":"Thanksbuyer Online,SDR Radio, Testers and Measurement devices, Astronomy products,  Audio Amplifer and Decoders","version":"1.0","type":"link"}