Matek PDB XT60 PDB-XT60 W/ BEC 5V & 12V 2oz Copper For FPV Drone Quadcopter QAV210 QAV-R QAV-X

Matek PDB XT60 PDB-XT60 W/ BEC 5V & 12V 2oz Copper For FPV Drone Quadcopter QAV210 QAV-R QAV-X

Features:     
• 2oz copper, 4-layers &1.6mm PCB.
• Built-in XT60 Socket
• Total 6 pairs ESC solder tabs are fit for H or X type frame
• 5V & 12V Output LED indicators & Short circuit tolerant    

Description:
General:
- Input voltage range (3S-4S LiPo operation): 9 - 18V DC
- Regulated 5V and 12V outputs
- LED power indicators ( 5V & 12V outputs )
- 6 ESC outputs & 1 pair VCC/GND pads

ESC outputs:
- Continuous current: 25A*4 or 15A*6
- Peak current (10 seconds/minute): 30A*4 or 20A*6

BEC 5V output:
- Designed for RC Receivers, Flight controllers, OSD, and Servos.
- DC/DC synchronous buck regulator.
- Voltage: 5.0 +/- 0.1VDC
- Continuous current: 2 Amps (Max.2.5A 10s/minute)
- Output Ripple: 40mV (VIn=16V, VOut=5V2A load)
- Short-circuit tolerant (5 seconds/minute)

BEC 12V output:
- Designed for Video TX or FPV camera with linear regulator.
- The battery should be 4S LiPo (13~18V DC)
- Voltage: 12.0 +/- 0.3VDC
- Continuous current: 500mA (Max.0.8A 5s/minute)
- Short-circuit tolerant (2 seconds/minute)

BEC 12V 3S LiPo
- Output voltage= 3S LiPo voltage -1V

Physical:
- Dimensions: 36 x 50 x 4 mm (without XT60)
- Mounting: 30.5 x 30.5mm, 3mm
- Weight: 7.5g (w/o XT60), 11g(w/ XT60)

Package Included:
- 1 x MATEK PDB XT60 with BEC 5V/12V    

Note:
- Pay attention to the input polarity, do not input reverse connection, short circuit!
- Do not touch the carbon fiber board behind the distribution board, as this may cause a short circuit.
- When using 4S, the 12V regulated output can last 500mA; the voltage regulation accuracy is 2.5%;
- 12V regulator chip also supports 3S battery input, but the output voltage = 3S real-time voltage -1V;
- The BEC 12V is available for up to a 12V camera and a 600mW image transmission device.