HamGeek Pluto Pro+ Upgraded V0.37 SDR Radio 70MHz-6GHz AD9363 2TX 2RX Transceiver for Gigabit Ethernet

* Without Antennas

* With Four Antennas

HamGeek Pluto Pro+ is a software-upgraded version developed from the original Pluto SDR platform. It supports dual transmit and dual receive at the antenna interface, allowing all four SMA ports to be used.

It is a powerful software-defined radio (SDR) platform featuring 2TX and 2RX operation, Gigabit Ethernet connectivity, and Micro SD card support. Designed with reference to the well-known ADI ADALM-PLUTO architecture, HamGeek Pluto Pro+ enhances the original design by addressing some of its limitations and providing improved flexibility for SDR applications.

* ADC/DAC: AD9363 (Can be hacked to AD9361 or AD9364)

* Channels: 2 Transmit Channels, 2 Receive Channels

* RF Range: 70MHZ~6GHZ

* Reference Clock: VCTCXO 40MHz, 0.5ppm

* SOC: Zynq7010 FPGA, 28K Logic Cells

* RAM: 512MB

* FLASH: 32MB

* USB: USB2.0, supports OTG

* Ethernet: 1000Mbps

* Micro SD: Supports booting from Micro SD card

* DC Input: 5V±0.5V, 2A (Micro USB)

* Shell: Aluminum alloy shell

* Signal Bandwidth: 200KHz-20MHz (AD9363)

Please note that all IO levels are 1.8V.

3.1 When using the official firmware for ADI-PlutoSDR, please connect to URST-MI052.

3.2 When using Pluto+ firmware and need to support Ethernet, please connect URST-MIO46

3.3 When using SD card to boot, please connect SD-H to 1V8

3.4 When using JTAG to debug, please connect JTAG# to GND

3.5 Please connect EXCLK to GND when using external reference clock input

* PTT drives optocouplers through GPIO0 (MI00), which requires an external relay or control circuit.

* At any time, you can press the DFU button and power on PLUTO+ again to enter the DFU mode, but you need to connect the URST jumper to MI052.

* You can connect a cable to input an external high-precision reference clock for AD9363 through the IPEX interface.

* The main level should not exceed 3.3V, and the EXCLK jumper needs to be connected to GND to turn off the built-in clock

Calibrate the Frequency of Built-in VCTCXO:

* The frequency of the 40M clock can be fine-tuned by adjusting the adjustable resistor next to the VCTCXO, provided that you have a reference signal source.

* Support booting via SD card, need to connect SD-H jumper to 1V8.

* 1 x HamGeek Pluto Pro+ SDR radio

* 2 x USB cables

* 1 x HamGeek Pluto Pro+ SDR radio

* 2 x USB cables

* 1 x 8dBi 2.4GHz/5GHz/5.8GHz antenna

* 1 x 5dBi 40MHz-860MHz antenna

* 1 x 40MHz-6GHz telescopic antenna

* 1 x 12dBi 700MHz-2700MHz antenna

* Package weight: 0.4kg (Without Antennas); 1kg (With Four Antennas)