RC Car Chassis Smart Robot Chassis Assembled Standard Version Servo Steering With Bus Encoder Motor

RC Car Chassis Smart Robot Chassis Assembled Standard Version Servo Steering With Bus Encoder Motor

Features:
- Assembled RC car chassis model
- Dual-motor drive
- Steering gear steering structure
- Aluminum alloy bottom plate
- Premium anti-skid tires

Car Model Related Parameters:
- Base plate material: aluminum alloy
- Steering mode: steering of front wheel servo
- Drive mode: dual-motor drive for rear wheels, active differential is also possible
- Motor power: 7W
- Motor working voltage: 5-12V
- Encoder working voltage: 5V
- Servo working voltage: standard version (4.8-6V)
- Encoder accuracy: one gear revolution, 1560 transition edges for the standard version, 520 transition edges for the faster version
- Tires: 65mm high-quality anti-skid tires

Standard Version:
- Motor speed: 500rpm
- Motor speed ratio: 1:30
- Maximum speed: 1.2 m/s
- Load capacity: 4kg
- Servo model: MG996
- Servo torque: 13kg.cm

Attention:
- The above parameters are tested at 12V battery power supply. Battery is not included.

MG996 Metal Analog Servo:
- N.W.: 60g
- Product size: 40x20x40.5mm
- Rotation speed: 0.16sec/60° (6v)
- Servo accuracy: 0.24°
- Locked-rotor torque: 15kg.cm (6.6v)
- Number of gear teeth: 25T
- Gear type: metal
- Power supply voltage: 4.8-6V
- Rotation angle: 180° speed adjustable
- Control method: PWM pulse signal
- Pulse width range: 0.5ms-2.5ms
- Control cycle: 20ms
- No-load current: 100mA
- Product line length: 30cm


Bus Encoder Motor:
An MCU processor is integrated on the basis of the encoder motor to realize the motor PID closed-loop control. Users only need to give servo rotation and speed commands through serial port to achieve motor closed-loop control. You don't need to write PID closed-loop control program, and it is easy to use. It i for users who want closed-loop control but do not understand PID. Control protocol is provided.


Package Included:
- 1 x Set of Car Chassis

Note:
- It is assembled.
- Controller board and Li-Po battery (7.4V, 2500mAH) are not included.