| Quantity | 3+ units | 10+ units | 30+ units | 50+ units | More |
|---|---|---|---|---|---|
| Price /Unit | $18.97 | $18.59 | $18.00 | $17.23 | Contact US |
YDJS-1210 0-10V Output Electronic Throttle Controller Accelerator Forklift Accessory for HELI/HC/TAILIFT/LONGKING/LiuGong
$40.32
YDJS-4836 3.6-0V Output Electronic Throttle Controller Accelerator Forklift Accessory for HELI/HC/TAILIFT/LONGKING/LiuGong
$40.32
YDJS-128005 0-5V Output Electronic Throttle Controller Accelerator Forklift Accessory for HELI/HC/TAILIFT/LONGKING/LiuGong
$40.32
OE 234-4381 For Nissan Altima 2007-2013 2.5L 3.5L O2 Oxygen Sensor Downstream
Features:
- Corrosion-resistant stainless steel construction
- PTFE filter blocks efficiency-robbing contaminants
- Refined zirconia element improves sensor response
- High quality maximizes engine performance and fuel efficiency while reducing fuel consumption and harmful emissions
Specifications:
- Placement on Vehicle: Downstream,Sensor 2,Rear,Post-Cat,Under
- Manufacturer Part Number: YIT000070
- Fitment: For 2007-2013 Nissan Altima 2.5L 3.5L
- Interchange Part Number: 234-4381
- Fitment Type: Direct Replacement
- Sensor Type: Heated
- Connector Gender: Male
- Wires Quantity: 4 Wire Leads
- Installation Type: Screw
- Wire Harness Length: 10.71"
- Thread Diameter: 0.71"
Fitment:
- For Infiniti QX56 2011-2013
- For Infiniti QX80 2014-2015
- For Nissan Altima 2007-2013
- For Nissan GT-R 2009-2015
- For Nissan Maxima 2009-2014
- For Nissan Murano 2009-2011
- For Nissan NV 2012-2014
- For Nissan Quest 2011
Package Included:
- 1 x O2 Oxygen Sensor
How do I know the O2 sensor Fit nor Not?
Must Know Before Buying:
l What is Bank 1?
Bank 1 is where the Number 1 cylinder is located. This is always the forward most cylinder.
l What is Sensor 1?
Sensor 1 is the O2 sensor that is located before or upstream of the catalytic converter. (Pre-cat)
So then if your diagnostic code is B1 S2 that means Bank 1 Sensor 2 down stream (post-cat).
l If its B2 S2 that means Bank 2 (opposite Bank to Bank 1) and the downstream after cat o2 sensor.
1.Compare the original and the new oxygen sensor(s) for the correct thread size
2. Make sure the connector detail,and overall length.To the fished overall length to match the original or easy to install.
3.Please check Compatibility chart on eBay listing to confirm that this part fits your vehicle.
4.If you encounter model/functional compatibility issue, please contact us for assistance. We will help you exchange to compatible item (if available).
