Original Portable USB Programming Cable with Universal K Connector for Baofeng BF888S UV5R

Original Portable USB Programming Cable with Universal K Connector for Baofeng BF888S UV5R

USB Driving Program Download:
- http://www.baofengradio.com/download.asp
- Note: This is not the programming software.

Using Instruction:
- Prepare: 1 x USB programming cable, 1 x computer (not included), USB driving program, programming software (not included), walkie talkies that need frequency modulation (not included)

Step 1:
- Plug the USB programming cable into the computer, and plug the other end of the programming cable into the interface of the walkie talkie.
- If you are using a desktop computer, it is recommended to plug the USB into the USB interface at the back of the PC case, as the voltage of the USB interface in the back is relatively stable, and it is not easy to damage the programming cable.

Step 2: Install the USB driver for the programming cable
- Please install according to your operating system:
  If it is an operating system for XP, please install the XP version of the driver;
  If it is an operating system for Win7, please install the WIN7 version driver.
- After successful connection, you can see the port number in the device manager of the computer. The specific operation is as follows: right-click the computer icon on the desktop and select <Device Manager>
- Kind reminder: Please note down the serial port number and it will be used for programming later.

Step 3: Open the programming software and perform programming operations
- Set communication port number: the communication port number set should be consistent with the port number recognized by the device manager.
- Familiar with operating buttons: each programming software interface is very simple, consisting of several commonly used toolbar buttons such as the frequency reading button, frequency writing button, open file, save file, etc.
- Formally perform programming operations: set the transmission frequency, reception frequency, decoding, encoding, etc. during operation. After setting up, program it to the walkie talkie.

Step 4: Test intercom calls
- Set the completed walkie talkies to the same channel and conduct a call test. If it is normal, then your operation has been successful.

Precautions:
- Please be sure to check whether the USB driver installation was successful in the Device Manager.
- When setting the frequency of each channel, the frequency of transmission and reception must be the same as the CTCSS, otherwise calls cannot be made normally.

Package Included:
- 1 x USB Programming Cable