X1 Digital Interface Module XU208 XMOS USB Board U8 Upgraded Version DSD DOP for Audio Amplifier

X1 Digital Interface Module XU208 XMOS USB Board U8 Upgraded Version DSD DOP for Audio Amplifier

Drive and information: Click here

Description:
- XCORE-200 new XMOS interface
- The Second-generation XMOS chip XU208 developed USB interface, support firmware upgrade
- Memory is twice  than the U8, computing speed of 1000 MIPS, higher than the U8 500MIPS
- Japan's ultra-low phase noise KDS TCXO, frequency accuracy of up 2PPM, RMS JITTER is in 0.5PS less
- This board  used with MAC and LINUX do not need to install the driver, in the WINDOWS system, need install special drivers. if you need. Please contact us
- PCB size: 85*43mm

Specifications:
Each output interface supports sample rates:
- PCM: 44.1KHz, 48KHz, 88.2KHz, 96KHz, 176.4KHz, 192KHz, 352.8KHz, 384KHz                                               
- I2S out support full sample rate, S / PDIF supports up to 192KHz
- DSD: 2.8 MHz (DSD64) - DoP, native     5.6 MHz (DSD128) - DoP, native     11.2 MHz (DSD256) - native                
- I2S out support full DSD format, S / PDIF and AES / EBU support DSD64 DOP mode]
- Bits wide: The highest 32 bit over I2S output  ;  The highest 24 bit over S / PDIF

Electrical Interface Standard:
- USB input socket is a standard USB-B type female, USB power supply range 4.5V-5.1V
- RCA connector outputs standard S / PDIF signal level is 550mV (standard connection load), the output impedance of 75 ohms

Design details:
- Carry out electricity as the mother of the acoustic design concept, pay attention to the power supply circuit design, high-performance, low noise and fast response LDO as the main power source. The entire board using a 2-way power supply independent LDO, wherein the clock section even using ADI's ultra low noise LDO, in order to ensure the ultimate output performance laid a solid foundation

- PCB board with 4-layer circuit board design, ensure that you have full power and ground plane layer, using the method of high-speed digital design, signal integrity and power integrity of the entire board. The clock signal for special treatment, using package design and precise impedance control, thereby ensuring the signal quality and increase the clock anti-jamming capability. Input and output signals follow a standard design, especially high-speed USB signals using a 90 ohm differential impedance control

System Compatibility:
- Windows XP, Windows 7, Windows 8; 32/64 bit, you need to install special drivers
- Native MacOS 10.6 and later,  the system comes with drivers
- Native Linux with UAC2 compliant kernel, using the system comes with drivers
- Android OS 4.2 and above,  need to support OTG function

Package List:
- 1 x Module