Altera Cyclone IV FPGA Development Board EP4CE6E22C8N + Altera USB Blaster Programmer

Altera Cyclone IV FPGA Development Board EP4CE6E22C8N + Altera USB Blaster Programmer

Description:
The easyFPGA-Cyclone-IV development board provides a complete hardware environment for designers to accelerate their time to market.The kit delivers a stable platform to develop and test designs targeted to the low-cost and low-power Altera Cyclone IV FPGA. The installed Cyclone IV device offers a prototyping environment to effectively demonstrate the enhanced benefits of low-cost Altera FPGA solutions. Reference designs are included with the kit to exercise standard peripherals on the evaluation board for a quick start to device familiarization.
 
Features:
- FPGA: Altera Cyclone IV FPGA EP4CE6E22C8N
- JTAG Port: On-board JTAG Port for programming
- SDRAM: One 64Mbit Single Data Rate Synchronous Dynamic RAM memory chip
- Flash: 32Mbit NOR Flash memory: Support Byte (8-bits)/Word (16-bits) mode
- Series Flash: EPCS4 4Mbit
- PS2 Port: Provides the PS2 port for Mouse and Keyboard
- Pushbutton switches: 4 User Keys- Normally high; generates one active-low pulse when the switch is pressed
- Infrared Receiver: Communicate with a Remoter for wireless control
-General User Interfaces: 4 User LEDs (Active low) - 4 digit 7-segment displays (Active high)  Active Type Buzzer
- System Clock inputs: 48MHz oscillator
- VGA output: Uses a 8-bit resistor-network DAC under RGB565 Mode With 15-pin high-density D-sub connector
- AD Circuit and SMA input: Use an AD chip Use a SMA port for AD signal input
- Voltage Regulator Circuit: Provides 1.2V, 2.5V and 3.3V for system power supply
- Jumper：Selection for External or on-board AD signal source.
- On-board USB to TTL/RS232 Module: Use PL2303 for USB-TTL/RS232 Converting (Without DB-9 serial connector)
- 26-PIN Expansion Headers: Altera Cyclone IV I/O pins, as well as 3 power and ground lines, are brought out to the 26-pin expansion connectors
 
Altera FPGA CPLD USB Blaster programmer:
- Fully compatible with original Altera USB-Blaster.
- Supported target voltage: 2.0V-5.5V
- Support all ALTERA deveice.
- CPLD: MAX 3000A、MAX 7000A、MAX 7000B、MAX 7000S、MAX 9000、MAX 9000A and MAX II.
- FPGA: Stratix、Stratix II、Stratix GX、Cyclone、Cyclone II、Cyclone III、ACEX 1K、APEX II、APEX 20K、APEX 20KE、APEX 20KC、FLEX 10K、FLEX 10KE、FLEX 10KA、FLEX 6000、FLEX 8000、EPCS1、EPCS4、EPCS16、EPCS64EPC1、EPC4、EPC8、EPC16
- Support: JTAG, AS, PS Mode.
- Support NiosII embeded core based debug,
- Supports Quartus II SignalTap® II Logic Analyzer (for logic analysis)
- High performance, 6 times faster than ByteBlasterII !!
- USB interface with status and Power LED.

Package Included:
- 1 x FPGA EP4CE6E22C8N Board
- 1 x USB Blaster Programmer with Cable
- 1 x Remote Controller
- 1 x USB Cable