• GEPRC ExpressLRS 915MHz (FCC) ELRS Nano FPV Receiver Module + Short Version T-type Antenna Support WiFi Firmware Upgrade
  • GEPRC ExpressLRS 915MHz (FCC) ELRS Nano FPV Receiver Module + Short Version T-type Antenna Support WiFi Firmware Upgrade
  • GEPRC ExpressLRS 915MHz (FCC) ELRS Nano FPV Receiver Module + Short Version T-type Antenna Support WiFi Firmware Upgrade
  • GEPRC ExpressLRS 915MHz (FCC) ELRS Nano FPV Receiver Module + Short Version T-type Antenna Support WiFi Firmware Upgrade
  • GEPRC ExpressLRS 915MHz (FCC) ELRS Nano FPV Receiver Module + Short Version T-type Antenna Support WiFi Firmware Upgrade
  • GEPRC ExpressLRS 915MHz (FCC) ELRS Nano FPV Receiver Module + Short Version T-type Antenna Support WiFi Firmware Upgrade

GEPRC ExpressLRS 915MHz (FCC) ELRS Nano FPV Receiver Module + Short Version T-type Antenna Support WiFi Firmware Upgrade

Availability: In stock, usually dispatched in 1 business day

  • Price:$20.42
  • Price in reward points: 204 Reward Points: 2
  • Quantity 3+ units 10+ units 30+ units 50+ units More
    Price /Unit $20.01 $19.60 $18.99 $18.17 Contact US
Quantity:

GEPRC ExpressLRS 915MHz (FCC) ELRS Nano FPV Receiver Module + Short Version T-type Antenna Support WiFi Firmware Upgrade

Description:

- GEPRC ELRS Nano receiver is a new generation remote control system developed based on the ExpressLRS open source project. ExpressLRS sets new standards for long-range connection, low latency and maximum refresh rate of 500hz.
- GEPRC ELRS Nano receivers are available in 915/868MHz and 2.4GHz versions with maximum refresh rate of 500Hz and can be used with GEPRC ELRS-series products or other ELRS-compatible devices.

Specifications:
- Size: 17mm x 11mm
- Weight: 0.6g (receiver only)
- Frequency band: 915MHz FCC / 868MHz EU/2.4GHz ISM
- Input voltage: 5V
- Antenna connector: ipex1

Features:
- Small size: 17 x 11mm
- Light weight: 0.6g
- Support WIFI Upgrade firmware
- ELRS open source project, remote control
- Easy to use

Package Included:
- 1 x ELRS Nano Receiver
- 1 x T-type Antenna
- 2 x Heat Shrink Tube
- 4 x Silicone Cable (Black, red, yellow, green)
- 1 x 4Pin Connector
- 1 x Instruction Manual


Connection Diagram of ELRS Nano Receiver and Flight Controller:


Open BETaflight, go to the port interface,. According to the welding situation, turn on the (serial digital receiver) switch of the corresponding port (take port 2 as an example), then save and restart.


Set the receiver mode to (serial digital receiver) and change the serial digital receiver protocol to (CRSF)


Write a review

Note: We will keep it confidential.
Note: HTML is not translated!
 
Captcha