HackRF One Starter HackRF One SDR with Shielding Cover Aluminum Shell + TCXO Simulate GPS

HackRF One Starter HackRF One SDR with Shielding Cover Aluminum Shell + TCXO Simulate GPS

Description:
HackRF One is the current hardware platform for the HackRF project. It is a Software Defined Radio peripheral capable of transmission or reception of radio signals from 1 MHz to 6 GHz. Designed to enable test and development of modern and next generation radio technologies, HackRF One is an open source hardware platform that can be used as a USB peripheral or programmed for stand-alone operation.

Using a Japanese TCXO crystal oscillator, 0.5PPM, each crystal module has actually been tested by GPS simulation, the effect is very good.

Features:
- Half-duplex transceiver
- Operating freq: 1 MHz to 6 GHz
- Supported sample rates: 2 Msps to 20 Msps (quadrature)
- Resolution: 8 bits
- Interface: High Speed USB (with USB Micro-B connector)
- Power supply: USB bus power
- Software-controlled antenna port power (max 50 mA at 3.3 V)
- SMA female antenna connector (50 ohms)
- SMA female clock input and output for synchronization
- Convenient buttons for programming
- Pin headers for expansion
- Portable
- Open source

Using HackRF One's Buttons:
The RESET button resets the microcontroller. This is a reboot that should result in a USB re-enumeration.

The DFU button invokes a USB DFU bootloader located in the microcontroller's ROM. This bootloader makes it possible to unbrick a HackRF One with damaged firmware because the ROM cannot be overwritten.

To invoke DFU mode: Press and hold the DFU button. While holding the DFU button, reset the HackRF One either by pressing and releasing the RESET button or by powering on the HackRF One. Release the DFU button.

The DFU button only invokes the bootloader during reset. This means that it can be used for other functions by custom firmware.

Package Included:
- 1 x Set of HackRF One SDR