For Raspberry Pi X850 mSATA SSD Hard Drive Expansion Board Ideal NAS Storage Solution Support 1TB

For Raspberry Pi X850 mSATA SSD Hard Drive Expansion Board Ideal NAS Storage Solution Support 1TB

Products need to be used with X850 mSATA SSD hard drive expansion board:
- X850 expansion board (this product)
- For Raspberry Pi 3B+/3B (prepare by yourself)
- 2.5 inch mSATA hard disk (prepare by yourself)
- Micro SD card / TF card (prepare by yourself)

Description:
- X850 only supports MSATA SSD hard drives. It is an expansion board designed for Raspberry Pi storage.
- Suitable for Raspberry Pi 3B+/3B; (also suitable for ROCK 64 development board).
- Operating system: For Raspberry Pi operating systems.
- Power requirements: Your board for Raspberry Pi directly supplies power. External power supply is not needed.

Refer to More English Information:
http://www.raspberrypiwiki.com/index.php/X850

Upgrade Instructions:
- When X850 is used as the boot hard disk, the problem that reboot is not supported is solved;
- Supports installation under the motherboard for Raspberry Pi; retains GPIO; in fact, it can also be installed on the motherboard for Raspberry Pi (but you need to use m2.5x20 copper pillars, purchased separately from our store;)
- Same size as the size of the motherboard for Raspberry Pi
- Change power supply method (use Micro usb power supply to replace GPIO power supply, additional power supply may be needed only when using a large capacity hard disk)
- All use patch processing technology, product quality is more reliable.

Power Supply:
- Power supply via the motherboard for Raspberry Pi (additional power supply is only required when using a large-capacity hard drive)

Features:
- Supports up to 1TB mSATA SSD
- Support hard disk system installation and startup
- Reserve a Micro-USB power socket to facilitate additional power supply to a large-capacity mSATA SSD
- Powered via the USB port of the motherboard for Raspberry Pi, no external power supply required
- Using super high speed USB 3.0 to SATA to 6.0Gb/s bridge controller
- USB3.0 super high-speed connection to PC or MAC for data transmission
- USB2.0 high-speed data transfer with connection for Raspberry Pi
- No driver required, fully suitable for Raspberry Pi
- Ideal storage expansion solution for Raspberry Pi
- Special USB port connection board without any cable connection
- Easy to assemble by yourself

Package Included:
- 1 x X850 Expansion Board
- 1 x USB 3.0 Cable 60cm
- 1 x USB Connector
- 1 x Bag of Screws

Note:
- Assembling is needed.
- Motherboard for Raspberry Pi is not included.
- X850 expansion board is for mSATA SSD and HDD shown in the picture bellow. They are not included in the package, for demonstration purposes only.