Pixhawk PRO Flight Controller with GPS and V5 500MW 915Mhz Telemetry Radio for Quadcopter Ardupilot

Pixhawk PRO Flight Controller with GPS and V5 500MW 915Mhz Telemetry Radio for Quadcopter Ardupilot

Features:
- Pixhawk PRO supports the latest official firmware for Ardupilot and PX4
- Telemetry radio modules can be used for wireless communication between Pixhawk and computer or mobile phone
- Advanced 32-bit high-performance processors (2MB flash) for ARM CortexM4 can run RTOS real-time operating system for NuttX
- 14 PWM / servo output
- Bus interface (UART, I2C, SPI and CAN)
- The integrated backup power and backup controller fails, the primary controller fails over to the backup control is safe
- Provide automatic and manual modes
- Provide redundant power input and fail-over
- Multi-color LED lights
- Provide multi-tone buzzer Interface
- Micro SD recording flight data
- Type-C USB port
- GH1.25 port

Interfaces:
- 5 high voltage compatible UART 1 and 2 with hardware flow control
- 2 CAN
- Spektrum DSM / DSM2 / DSM-X satellite receiver compatible input
- For Futaba SBUS compatible inputs and outputs
- PPM signal input
- RSSI (PWM or voltage) input
- I2C
- SPI
- 3.3 and 6.6VADC input
- External type-c USB interface

Package Included:
- 1 x Pixhawk PRO
- 1 x PPM board
- 1 x I2C board
- 1 x RGB LED module
- 1 x OLED module
- 1 x Safety button and buzzer
- 1 x TF card & SD card adapter
- 1 x Vibration damper plate for flight controller
- 1 x 3D power module
- 1 x GPS holder
- 1 x M8N GPS
- 2 x V5 500MW 915Mhz telemetry radios
- 2 x Antennas
- 1 x Set of cables (including 4P GH1.25, 6P GH1.25 and 2.54Pin)