CNC 400W Brushless DC Spindle Motor Air-Cooled + BLDC Motor Driver Controller for Engraving Machine WS55-180

CNC 400W Brushless DC Spindle Motor Air-Cooled + BLDC Motor Driver Controller for Engraving Machine WS55-180

Brushless Air-cooled Spindle DC Motor Specification:
- Model: WS55-180 Spindle Motor for Engraving Machine
- Power: 400W    
- Operating voltage :48VDC    
- Maximum working current: 10A    
- Maximum Power: 0.4KW    
- Rotation Speed :12000r / min.    
- Torque: 0.5294 N.m    
- Insulation resistance:> 2 megohm    
- Dielectric strength: 400V    
- Diameter: 55mm    
- Motor Overall length: 175mm (includes gripping parts and motor)    
- Axis collet Length: 43mm    
- Diameter of ER11 collet:3.175mm(you can change your collet size)    
- The spindle runout: about 0.01-0.03.    
- Weight: 1.2kg    
- Can be used for engraving metal or nonmetal materials.    
     
WS55-180  BLDC Motor Driver /MACH3 Main shaft speed controller:
- Rated voltage: 20-50VDC
- Rated current: WS55-180: 10A
- Current limit: 15A
- Maximum support speed: Support speed 20000RPM and above, the specific speed depends on the motor itself and the load
- Two ways of regulating speed:
  External potentiometer: through this potentiometer speed;
  External voltage: external 10VDC voltage speed regulation;
  Note: two speed can bot be available at the same time;
- Speed output:
  PG signal: the port and the ground , the 5V speed pulse output.
  Output frequency is set to P (Hz), the number of motor is N, the speed is F (RPM), the output speed frequency: P=F*N/60;
- Alarm output
  ALM signal: the port and the ground,the 5V alarm pulse output.
- Positive inversion function
  F/R: The motor turn can be changed when toggle switch
- Start stop : Two control modes:
  External switch EN: switch by switch;
  The side toggle switch en: for toggle switch on the white part is downwards to start; for toggle switch the white part is horizontal, to the inside dial is to start
  Note: Can control one of them, off the one, the other is available.
- Stall protection: When stall, the motor stops working.
- Power light: Green light: power on
- Status light: Red light: When standby, two consecutive flashes, after the boot off. Flashing when there is a fault
- Insulation resistance: >100M under normal temperature and pressure
- Insulation strength: Under normal temperature and pressure, 0.5KV, 1 minutes
- Storage temperature: -20  ~ +65 deg C
- Occasion: Avoid direct contact with dust, fumes and corrosive gases.
- Operating emperature: 0-45 C
- Humidity:< 80%, no frost, frost free
- Vibration: MAX 5.9m/S2
- Storage humidity:0~95%RH
- Size:96mm (L) *67mm (W) *37mm (H)
- Weight: 195g (with potentiometer and switch)

Package include:
- 1 x 400W DC Brushless Air-cooled motor with 3.175 collet     
- 1 x Motor driver